"LinteL LIMS” laboratory information management system is a software for quality control laboratories, which is intended for automation of laboratory activities and reduction of costs for testing.

LinteL ATV-21 Automatic closed cup tester Pensky – Martens method Standards implemented GOST R EN ISO 2719-2008 GOST ISO 2719-2013 GOST 6356-75

LinteL ATVO-21 Automatic open cup tester (with gas ignition) Cleveland method Standards implemented GOST 4333-2014 GOST 33141-2014 ASTM D-92 ISO 2592-73

LinteL KISH-20М4 AUTOMATIC SOFTENING POINT TESTER FOR PETROLEUM BITUMEN Standards implemented GOST 11506-73 GOST 33142-2014

The electrolysis unit UR.R-8-2 is intended for the preparation and dispensing of sodium hypochlorite solution, obtained from the sodium chloride solution by electrolysis. Sodium hypochlorite is fed to the block of microfilters. Dose for active chlorine 3 mg / l. At a dose of 3 mg / l, 75 liters of sodium hypochlorite solution are needed per day.

The principle of operation of the neutralizer is the treatment of waste acid-base solutions in a reagent manner. The upper cover of the neutralizer is equipped with: - a vent; - inspection hatch; - control the pH of the solution.

Installation of plates with a diameter up to 200 mm. System of winding protective layer of UV films. Circular and linear knives to remove film residue. Evenly warmed up working zone.

Cutting plates and substrates with a diameter of up to 150 mm. High precision precision spindle on 1.2 kW air bearings. Rigid installation design that provides minimal vibration when cutting. Friendly software interface.

Low wear and high cutting ability. High rigidity. A wide range of processed materials. Various concentrations of diamond grains are possible to achieve the best cutting quality.

Designed for drilling and milling holes in the dielectric substrates of the cellars or policor. The substrate is drilled using diamond horseshoe-shaped drills, which are installed in the spindle collet. To obtain high quality holes, we used a spindle for precision machining with a beat at the end of the shaft of 3 microns.